Claimer Pan Kit

Heavy gauge steel, S/B Chevy oil pan kit can be used for building any racing pan. Claimer pan kit includes bottom, side, 2 gate assemblies, and drain plug. Bare oil pan sold separately.

1. Cut off pan 51/2” below lip.
2. Position kit on pan and square using side piece. To fit stock starter allow 5” clearance between top of lid and top of pan. Pan will then be 71/2” deep. Tack in position.
Note: If you wish to have pan deeper, straighten the front lip
3. Weld in gate assemblies. (Gates swing toward pump).
4. Weld on side piece.
5. To prevent warping during welding, bolt pan on block. Welding Tip: Tack weld pan together before finishing welding, to prevent warping.
Note: Kit can be installed on Chevy truck oil pan.